In a message dated 1/13/02 11:22:47 AM, andrewbell@QWEST.NET writes:

<< wander9 wrote:

> I installed my driveshaft for the first time.  Whoever removed it
> (previous owner, for towing reasons) >

That may not be the only reason it was removed.

> I installed it, and expected to have a big vibration, but ended up
> with a very minor one, at around 100kph.
> Still, I'd like to have none at all.  Is this possible?

Yes, check the condition of your U-joints.

> I was missing one of the nuts, so I used a normal M10x1.0 nut with a
> lock washer, where not of the others have a washer of any kind.  Is
> this enough to throw it off?

It is doubtful that a mere mortal would be able to detect the imbalance.

> Do I have to go through all possible combinations (ie 4x4=16)
> positions of the driveshaft in order to get no vibrations?
> ...Markus >>

Unless the damper was also removed, there are only 4 "combinations" to try.
But, that is a futile exercise because the driveshaft was not balanced in
situ.  If the driveshaft was separated at the rubber damper, it should be put
together with the U-joints in phase.  Check the condition of the front wheel
bearings, CV-joints and center driveshaft U-joints.

Rich