

| Subject: | Re: Shims Swaybars CVs and Steve's Spings |
| From: | Ben McCafferty |
| Date: | Thu, 21 Feb 2002 21:18:53 -0800 |
Derrek, did you have a front sway bar to begin with, and just put on a thicker one? Or were you bare up front? tx, bmc :) "Faith will move mountains, but you'd better bring a shovel...." > From: John Clemens <jbclem@EARTHLINK.NET> > Reply-To: John Clemens <jbclem@EARTHLINK.NET> > Date: Thu, 21 Feb 2002 16:27:44 -0800 > To: vanagon@GERRY.VANAGON.COM > Subject: Re: Shims Swaybars CVs and Steve's Spings > > Derrek, > > Could you tell me where you bought the sway bars for you Vanagon, and any > other information that would be relevant. > > > Thanks, John > > > ----- Original Message ----- > From: "Derrek Wittmann" <kerred@HOTMAIL.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Thursday, February 21, 2002 11:06 AM > Subject: Shims Swaybars CVs and Steve's Spings > > >> I got a set of Steve's springs. They are great. My van was restored to the >> stock ride height plus a little. I added shims on all four corners. >> 12mm(1/2") in the front >> 19mm(3/4")+12mm(1/2") in the back. >> With all the shims I have added it is a little too tall in the back. This >> lead problems with my old cv's. I had to replace them with good used ones. >> The new steeper angle of my axle had changed the range of motion that my > CVs >> were going through. It was just too much for my worn out CVs. I still > have >> a slight vibration. I should take the small shim out but I like the way it >> looks. The rear axel to fender lip height is 18". The addition of a 1" >> swaybar in front made the biggest difference on the reduction of sway. >> Later I added a rear swaybar which I did not feel the effect of as much as > I >> did the front. >> >> Derrek Wittmann >> ----- Original Message ----- >> From: "phil stanhope" <napszeerf@YAHOO.COM> >> To: <vanagon@GERRY.VANAGON.COM> >> Sent: Thursday, February 21, 2002 6:17 AM >> Subject: Re: [VANAGON] New springs on my 1989 Vanagon with shims for the >> lefty camper sway >> >> >>> Could you say that this is a better solution to reduce >>> sway than to add front and rear sway bars? I would >>> much rather do this if it REALLY reduced swaying, and >>> from reading Developtrust's posts it seams to be so. >>> >>> >>> Phil, >>> 84' "Westy Millenium Falcon" >>> >>> >>> >> >
Have something to add on this topic today? Revive this thread in the forum »