Just use a large flat punch and a hammer to drive it out from the back.

Dennis

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
Of David Beierl
Sent: Wednesday, March 27, 2002 1:44 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Problems removing rear brake shoe pivot

At 12:42 PM 3/27/2002, Ron Maxseiner wrote:
>Hey I was trying to replace the rear bearings on my
>1985 vanagon.  I encountered a problem removing the
>'brake shoe pivot'.  (The V shaped thing at the bottom
>of the drum brake that holds the brake shoes).  The
>two bolts came out fine but the pin that goes through
>to the housing was stuck.  Rotating the brake shoe
>pivot only caused the pin to move in the housing.

That little guy is spot-welded onto the brake backing plate, so at this
point you might's well keep twisting until it comes loose -- you've
already
twisted the weld.  You can re-weld/braze or not as you like, the weld
basically keeps the part from getting lost in the factory.  Either way
clean up the place where the weld came apart so it will sit flush. The
pin
is a dowel pin, drive fit in both pivot and hub.

david

--
David Beierl - Providence, RI
  http://pws.prserv.net/synergy/Vanagon/
'84 Westy "Dutiful Passage"
'85 GL "Poor Relation"