Karl
I have never seen 60 over on a 1.9 only 20 over from Canada. send the
bearings to me if you still have then I would love to see them. I have had
40 over rear main bearings  made so that I can align bore the 20 overs that
have been done by Canada and I have added a over size thrust cut to my stock
of bearings so I can save a case that otherwise would be junk.
Bob
----- Original Message -----
From: "Karl Wolz" <wolzphoto@worldnet.att.net>
To: "Robert Donalds" <bostneng@FCL-US.NET>; <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, April 14, 2002 1:33 PM
Subject: Re: Re: 1.9L VW Remanufactured engines

> The impression that I've gotten is that all of the engines done by VW
Canada
> have been automatically align bored to .060 over, whether they need it or
> not.  Makes sense for production and inventory control reasons, but you're
> screwed if you need to rebuild it again later (like I was).
>
> Karl Wolz
>
> ----- Original Message -----
> From: "Robert Donalds" <bostneng@FCL-US.NET>
> To: <vanagon@GERRY.VANAGON.COM>
> Sent: Sunday, April 14, 2002 8:53 AM
> Subject: Re: 1.9L VW Remanufactured engines
>
>
> SpaceKommander wrote
>
> >Went to a VW dealership on Saturday and was told that yes, 1.9L
> >remanufactured wasserleakers are available for $3,048.00 - part number
> >025-100-031AX that has 12 month / 12,000 mile warranty. They seemed to
have
> >no further information, however. For example I asked if they were new or
> >remanufactured heads - they had no clue. Does anybody know what's up with
> >the VW motors? I don't want to give them $3000 for a rebuild that they
just
> >get from another rebuilder like GEX or whatever.
>
> I have 1.9 engines for $2300 and I can tell you what's inside why spend
more
> for a mystery engine and not get tech support
> I am near the phone today call me and I can set you up with a Quality long
> block
> Bob Donalds
> 1 508 653 7229
> http://www.bostonengine.com
>
>
>