Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: throttle cable
From:Stan Wilder
Date:Fri, 12 Apr 2002 16:22:59 -0500

Its not hard to replace.
Drop the spare tire carrier, take a few screws out of the cover and
loosen the one locking screw holding it.
The whole thing runs through a plastic housing.
Loosen the cable on the throttle body and you can pull it out through the
engine compartment.
They cables are only about $5.00 each
Remember to put a little lithium grease  (light weight/water proof) on
the cable as you go back in with it.
Don't go for overkill on the lube.

Stan Wilder

On Fri, 12 Apr 2002 11:46:25 -0600 John Brush <jbrush@AROS.NET> writes:
> Yikes! I was checking out the engine compartment of my 81 air cooled
> and
> noticed the throttle cable is getting frayed from rubbing against
> the hole
> in the compartment where it exits heading for the front end.
>
> How much fun is it to replace that baby? I have the aux furnace
> beneath
> the vehicle which makes all things fun going from front to back tons
> of
> fun. Looked in Bentley, and I'm sure its there somewhere, but I
> didn't
> find it.
>
> I found one message in the archive that described using 12 gauge
> wire
> pulled through in place of the cable, which seem like a good idea,
> just a
> fear of it coming loose :-) and not knowing how large the holes are
> that
> it passes through.
>
> Opinions on which way to pull it out? Never having seen one up
> close, can
> the new one be attached to the old one to and pulled through?
>
> I would appreciate any comments or suggestions, as this one can't
> wait too
> much longer.. <g>
>
> Thank a lot,
>
> John
>

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.