> 1.      Is it possible to replace this seal with the tranny in place.
> If so, how?  (I have a connection to get the seal

yes, super easy to do and you can EASILY do it in place.

> 2.      If I do not pull the tranny now, how much work is it to pull the
> tranny later, leaving the engine in place (or is this even possible?).

again, very easy. IMHO, it is easier to pull the tranny that it is to
pull the engine.

If i were you, i'd replace that main tranny & engine seal while it is
out. You can then deal w/ the seals under the cv's at a later time. But
doing those is super easy too. unbolt the CV, shove a screwdriving into
the center of that 'cup' that the cv bolts to and pop the seal out. Then
remove the next thing (nut, bolt, circlip? i forget) and then that 'cup'
will slide out. I've done this to 3 trannies and never needed any
special vw tool. So then you remove the plastic dirt-shield and you have
access to the next seal. Pry her out and slip the new one in place.
Reassamble. That is about it. But this can be done w/ the tranny in
place. But be sure to do that main tranny seal and the engine seal while
you have the tranny out!

cheers
matthew
86 syncro westy tiico
84 weekender

> Thanks for the advice on this one
>
> Philip