At 07:46 PM 5/3/2002, Eric Spletzer wrote:
>Hi all.
>
>So I posted yesterday about my water sensor not working, and I got a few
>responses about the contacts being corroded and the like and I went to check
>it out, and I can't seem to find the sensor at all.  My book says that the
>sensor is on top of the tank but only in the 88 models or later, but the
>panel on the front of my fridge clearly has a lights for the water and my
>manual talks about the water sensor. Anybody know what's up?  I have an 85
>Vanagon GL.

You have four stainless bolts in the side of the tank, ground and three
others which connect to a little black box in the "secret" compartment
forward of the tank, then a (green?) wire which connects to green wire on
LED panel connector.  With LED panel on, ground that green wire at the
connector (won't do any harm) -- the top light should light.  If it does,
your problem is toward the tank.  If it doesn't, the LED panel has a
problem, likely a blown IC (the left-hand one; the right-hand one does the
voltage meter and IIRC the flame detector).  It's an LM324 available from
Radio Shack for about $1.29 so it's not worth much time troubleshooting --
just replace the sucker.  While you're in there you could put in brighter
LEDs, especially the flame detector one.

If you're interested, there's a schematic of the water circuit on my website.

david

--
David Beierl - Providence, RI
  http://pws.prserv.net/synergy/Vanagon/
'84 Westy "Dutiful Passage"
'85 GL "Poor Relation"