In a message dated 5/3/02 9:26:55 PM, dhundt@PCEZ.COM writes:

<< Hey Matt,

you shouldn't have to remove any material from the diesel input shaft, it's

already the correct length for an I-4 engine. Probably not a big deal that

you have removed some, don't take any more off. Good luck with the

conversion.

Don >>
Sorry guys, this bit of wisdom is counter to my experience. Cost me $725 and
tax. I used the diesel trans and diesel input shaft, and broke out the 3/4
hub I had replaced 20K miles earlier. The depth of the pilot hole in the
crank on the Golf, Jetta etc. transverse mount engine is not as deep as the
diesel block. My trans guy had to take several mm from the shaft. My engine
was/currently is the RV digifanr from the 1990 GTi. So Matt, measure the
depth of the recess in the pilot hole on both engines and the difference is
what you need to take off.

Frank Grunthane