In a message dated 5/11/02 6:51:25 PM, rpwhitby@MINDSPRING.COM writes:

<< By the way, Bentley shows no such switch for my '87. Does't show controls
on the dash for the AC either.

How would I check this? Ground the switch wire perhaps?

 >>

Bob,

You are digging the hole in the right spot with the Bentley, just dig a
little deeper.  There are about 10 pages covering the A/C, refer to pages
97.137 through 97.145.  To isolate the A/C input to stabilizer control unit,
popping out the A/C Clutch Relay appears to be the most expediant way to go.
That is assuming that the conductor to the stabilizer control unit was not
severed and now dangling against something unnatural.

Rich