The great Air Cooled Vanagon parts dumping continues.
The several last items that I am liquidating are.
One Air Cooled DK Vanagon transmission, both very good boxes and I've run
in my Westy so I know that is good. Price $300.00 each and I good core
tranny that needs 3/4 Slider or Synchronizers $90.00.
Shipping weight on transmissions 90 pounds each.
----------------------
One 1980-83 Vanagon Rebuilt Air Cooled CV prefix engine with eight
thousand miles on it. I rebuilt this engine for a friend and he wrecked
his 81 Vanagon.
This is a short block engine with the following:
#1) No heads, but with lifters mated to the cam.
#2) Oil cooler
#3) Oil pump
#4) Oil filter mount
#5) Flywheel shims (no flywheel) hope they are right for your flywheel,
you'll haqve to check.
#6) I just busted the cylinder glaze and installed new rings when I
inspected the rod bearings. Everything OK.
#7) All crank and rod bearings are Standard (block has never been bored
for oversize main bearings.)
#8) One known flaw ...... oversize oil drain plug.
This engine will require break in procedures because of the new rings.
front seal # 021-105-247a
rear seal # 029-105=245b
Part number: 029198075OR CYLINDER & Mahle PISTON KIT
Price: $225.00 Quantity: 1 Total: $225.00
Part number: 021198481A MAIN BRGS T2 2000cc
Price: $53.02 Quantity: 1 Total: $53.02
Part number: 021198541 CAM BRGS T2 2.0L
Price: $15.00 Quantity: 1 Total: $15.00
Part number: 071198009A GASKET SET,
Price: $55.67 Quantity: 1 Total: $55.67
Part number: 025198151 RING SET
Price: $61.53 Quantity: 1 Total: $61.53
Part number: 039105701 ROD BEARING SET
Price: $17.55 Quantity: 1 Total: $17.55
new connecting rod nuts # 113-105-427
Part number: 022109309 Cam Follower
Price: $9.95 Quantity: 8 Total: $79.60
Part number: 022109021a Camshaft with gear
Price: $139.95 Quantity: 1 Total: $139.95
The parts above wre installed on the rebuild.
Engine price $ 800.00, check with Forward Air on rates on delivery,
shipping weight on pallet 180 pounds.
Ship From Forward Air DFW Airport, Dallas TX.
--------------------------
Last Item:
The full fuel injection system for an 80-83 Vanagon with Type IV engine;
The main parts are listed below:
Electronic Control Unit (JETRONIC) s Part # 039-906-021C
Auxiliary Air Valve Part # 0.280.140.101
Air Cleaner Top and Bottom with intake sleeve.
Air Flow Meter/Sensor Part # 0-280-200-030 with Air Fliter Box (alternate
Air Flow Meter with Air Filter Box 1976-1979)
Boot intake, to Air Flow sensor Part #071.129.967
Air Metering Body (throttle body)
Air distribution manifold with cold start valve Part # 0.280.170.026
(will not have EGR valve, it will be blocked off)
4 Boot Sleeves, manifold to intake manifolds. Part #039.133.241
Two intake manifolds, one right one left.
Four Fuel Injectors with holding clamps. Part # 0-280-159.114
Fuel Rail, left and right.
Thermo time switch. Part # 0.280.130.214
Double Relay (sometimes call combi relay)Relay #071-906-059 Left,
0-332-54-129 Right.
Throttle Valve switch. (Full throttle switch)
Engine Temperature Sensor Part # 0.280.130.012
Pressure Regulator (vacuum Limiter) Part # 0.280.160.100
Resistor Unit Part # 0.280.159.0010
Main Wire Loom, control head to everything else.
Secondary wire loom to Vehicle Power and Double relay.
New set Injector gaskets (4 small, 4 large) 311-198-261A
Two intake manifold block gaskets 022-129-707F
You will need to purchase several pieces of new vacuum lines and hoses
approximately $6.00
Price: $300.00

Call or E-mail if you have questions.

Stan Wilder
214-352-5396