The solder they use on A/C copper fittings is a very low grade of silver
solder.
Any A/C repair company should have it.
I think I'd just stop an A/C service truck in my neighborhood and let the
tech moonlight your little job in.

Stan Wilder

On Sat, 25 May 2002 22:23:25 -0400 Myron Lind <mdlind@RICA.NET> writes:
> Hello to all soldering/brazing experts.
>
> I am trying to add an AC unit into my 1982 diesel Westy by using the
> roof
> mount evaporator unit out of a 1985 van. The unit sits right behind
> my head
> (when I relax in the seat and imagine that I am actually driving),
> but with
> no modification will stick into the pop top hole. I was going to
> disassemble
> (OK, I have already disassembled) the ducting and make the unit a
> bit
> "smaller". In order to do this I need to change where the hoses come
> into
> the evaporator. There appears to be some sort of plastic coating
> over the
> copper, and it appears that coating would remove easily. I am
> curious as to
> what I should be looking for in terms of solder to properly reattach
> the
> ends once I have them where I want them. What is proper AC type
> solder?
>
> Myron Lind
> 82 Westy getting mechanical TDI
> 81 Westy that still runs great
>
> PS I have torch and am experienced at brazing thin walled steel
> bicycle
> frames.
>

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.