The shrouding is held on at the exhaust pipe studs and two bolts into the
case--nothing that holds the engine up.  Are you confused with the rear
heat shield/engine mount area?

                                                            Jay

Dave Baker <DBAKER5@KC.RR.COM>@gerry.vanagon.com> on 05/30/2002 11:20:21 AM

Please respond to Dave Baker <DBAKER5@KC.RR.COM>

Sent by:    Vanagon Mailing List <vanagon@gerry.vanagon.com>

To:    vanagon@GERRY.VANAGON.COM
cc:
Subject:    Push Rod Shield Cover Question

I'm now at the point where Bentley says, "Remove push rod shield cover," or
something like that.  (I don't have the book in front of me.)

Neither Benley nor Haynes addresses the procedure for doing this, and when
I
examine the shield, it appears that it is held in place by mounting
brackets
that also secure the engine.  Is this so?  If I take those bolts out is the
engine going to fall down on my head?  :)

Those of you who wish to follow my trials and tribulations of this head
gasket repair job may do so at the following link:

http://members.fortunecity.com/davebaker1/westy/id35.htm

TIA.

Dave in KC
85 Westy