Bummer!

I hate to admit it but back in the 70's a trusting friend loaned me his VW
van. Not paying attention on a freeway on ramp and trusting the driver ahead
of me to merge I glanced away for a moment. Of course the driver up front
stopped to look at traffic and I plowed into him and crushed the front of my
friends van. That cost me about $1500 which I willingly paid to my friend
who was like a saint about it. I don't think he ever fixed the front but the
money made him feel OK. Back then $1500 was about $4500 in today's money.
Since then I never trust people in front to merge properly and leave lots of
room up front for maneuvering around dumb drivers and my stupidity.

Guillermo-de-San-Diego
1989 Vanagon GL Camper

> Well after foolishly letting a friend drive my van I have some body work
to
> do. I've known this guy for a couple years and I told him to drive it like
a
> big truck. So of course he still thinks he is in his little Toyota and at
> the gas station as he is turning the rear end of the sliding door goes
into
> the cement pole, followed by the fender flare being demolished and the
seem
> split open. Boy was I mad, but he is my friend so I took it in stride and
> luckily he has the money to get it repaired. So I asked some body guys
> around town if they could fix it without bondo, and they said with new
> pieces. So where is the best place to get sheet metal, cost doesn't matter
> too much, as long as it is reasonable. I saw Bus Depot has a whole new
rear
> fender panel for $50 and they claim it is good European made. Any
> suggestions?
>
> Nathan
> 60 SO-23
> 85 Westy
> 86 Cabriolet
>
>
>
> _________________________________________________________________
> Send and receive Hotmail on your mobile device: http://mobile.msn.com