So, I put two new heads on the 89 (110,000 miles) and put new rings on the
pistons... Now it uses 1 quart of oil every 150 miles... obviously not an
option. I bet the rings are not seating right... even after 1,000 miles. It
was never burning oil before... and I am sure that I put the rings in the
right way. It drives fine but smokes, of course. It only kind of fouls out
cylinder #2... (so my suspect cylinder) the others are running a little
rich but no way near fouling out the plugs

So, I am going to put new pistons and cylinders on the beast...

Now my question is if I am already going this far why not split the case
and put new crank, cam and rod bearings in it... I have done it tons of
times on the old aircooled type 1... and there is no major difference here
other than size and coolant... and time

I know that the engine had overheated in the past and both heads were
cracked, from overheating I presume... but there is no knock or any other
symptoms of overheating... I wonder if it damaged the bearings when it
overheated...

Would you split the case and do the crank, cam bearings or just the
pistons/cylinder, rod bearings.

Any suggestions?

Markus Kruse, Ph.D.
World Wide Arts Resources, Corp.
absolutearts.com / wwar.com
761 Franklin Avenue
Columbus, Ohio 43205
USA

Tel:  614-221-7661
Fax: 614-221-1933
www: http://wwar.com
www: http://www.absolutearts.com