In a message dated 7/29/02 12:41:42 PM Pacific Daylight Time,
Malcolm.Stebbins@MSVU.CA writes:

<< Can anyone please tell me how to go about removing the badges
 without breaking them.  I looked at the under (interior) side and
 there are no metal rings/clips or anything holding the badges on, just
 looks like plastic pushed in through a hole and maybe then melted
 to hold the badges in place.  Thanks,  Malcolm >>

Malcolm,

The emblems are held in place primarily by double sided adhesive trim tape.
Probably 3M. There are small studs which are then pushed onto plastic
grommets. That is all. You can carefully pry the emblems off. I find they are
much easier to remove on a warn sunny day. The adhesive gets a bit softer
then. The studs in back are most likely used to locate the nameplate properly
more than any other purpose (IMHO).

BenT
http://hometown.aol.com/bentbtstr8/myhomepage/index.html