

| Subject: | Re: WESTY MIDDLE SEAT |
| From: | Cooper John LCDR ALCOM/J322 |
| Date: | Mon, 29 Jul 2002 22:44:04 -0000 |
Matt,
I have the middle seat installed. I didn't cut the floor. I bolted the
rails THROUGH the floor to the threaded holes underneath. First I removed
the plywood floor and located the proper holes. You will find plastic
"screws" in the holes to keep them sealed. I put the rails down over the
screws to determine which to remove. After I removed the proper screws, I
set the plywood back in, and drilled pilot holes using a small bit, about
1/8 inch, up through the bolt holes up from the beneath the van, being
careful not to touch the threads. I then removed the plywood again and
drilled down my new pilot holes. Finally, I bolted down through the carpet,
through my new holes, into the floor. The upside is, that like the posting
recently, the rails are raised above sill level, so I can remove the seat by
just removing the four bolts in the rails, and sliding the seat out. The
downside is that when I remove the seat, the rails are sitting on the floor
still. Trip hazzard? I have also found that with the seat folded forward,
I can still put down the bed. So, if I don't want to pull out the seat to
get to the fridge, I don't have to. I will try to take a couple of digital
pictures and send them to you. Frankly, I did it this way because I had
never seen the seats installed before and it seemed the way to do it! I
didn't think about cutting the plywood and carpet. Seems like a lot more
work.
John.
Date: Mon, 29 Jul 2002 15:35:05 -0400
From: "G. Matthew Bulley" <gmbulley@BULLEY-HEWLETT.COM>
Subject: Westy Middle Seat
Could one of you with a Westy middle seat take some digipix
of your
floor for me?
I have the seat, and the rails/bolts, but need a visual on
how VW sliced
the wooden floor, and where, etc.
P-mail is fine. Big files okay.
Pics with wife or girlfriend okay, too.
From historic, walkable Mount Olive, NC,
G. Matthew Bulley
Bulley-Hewlett
Corporate Communications
Business: www.bulley-hewlett.com
<http://bulley-hewlett.com/>
Home: www.MountOliveNC.info <http://www.mountolivenc.info/>Have something to add on this topic today? Revive this thread in the forum »