OK, I measured my '81 Westy tables.  The tables I measured are not actually the originals,
because I made new ones out of hardwood (much prettier).  However, when I made them I was
careful to duplicate both the size and the pivot placement, so they are identical to stock in
all dimensions.

Front table:  16 1/4 by 24 1/4.  Top is 30 3/4 from the floor when mounted.  The horizontal arm
reach is 10 5/8 from the center of the upright tube to the center of the pivot socket under the
table.  The center of the pivot socket is 8 1/8 from a long edge and 10 3/4 from a short edge.
It is not centered in either direction.

Rear table:  16 1/4 by 32.  Top is 28 3/4 from the floor when mounted.  The horizontal arm
reach is 18 1/4 from the center of the upright tube to the center of the pivot socket under the
table.  The center of the pivot socket is 6 3/4 from a long edge and 13 3/4 from a short edge.
It is not centered in either direction.

I hope this helps.

Bill

----- Original Message -----
From: "Joseph Angrisani" <JOE65@AOL.COM>

> Still trying to figure out this table leg thing (so the correct leg gets
> shipped the first time!), and I was wondering if a few of you with both
> tables and legs could go out to your early/mid-80's Westy with a tape measure.
>
> I was wondering if a few of you could send me your table dimensions, their
> locations F or R, and the heights off the main floor for both the front and
> rear tables.  Also, if you could, let me know if the "reach" of the two table
> legs are different...a measurement would be nice.  I'm trying to determine
> if, and how, the two legs are different.