Also what is the purpose of running the engine for a minute with the
valve
covers off before you do the adjusting? Is it to pump up the lifters?
------------------------------------
Give stuck lifters a chance to start using their internal spring again.

Stan

On Thu, 5 Sep 2002 16:54:19 -0500 Mark Ingalls <ingalls_mark@HOTMAIL.COM>
writes:
> On Stans web site he has in the valve adjusting procedure a step
> about
> removing #1 spark plug and inserting a piece of wire in order to
> determine
> TDC.
>
> I am inclined to just pop off both valve covers, pop off the
> distributor
> cap, note which cylinder the rotor tip is close to pointing to, then
> turning
> the engine until that cylinder is at TDC by using the mark on the
> pulley or
> 180 degrees opposite, whichever applies. That is how I do my type
> 1.
>
> Then you can watch the valves open and close as you rotate the
> engine to do
> the other valves, to double check that the valves are opening and
> closing
> when they are supposed to.
>
> Also what is the purpose of running the engine for a minute with the
> valve
> covers off before you do the adjusting? Is it to pump up the
> lifters?
>
> Sincerely,
> Mark I
>
> _________________________________________________________________
> Send and receive Hotmail on your mobile device:
> http://mobile.msn.com
>

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/web/.