On the 1.9 engine there is a block off plate on the front side of the left
head (driver's side).  I think this would be an ideal place to install the
sender for a coolant temp. gauge and possibly a  pressure gauge.  It is a
flat plate that is attached with two bolts and a gasket.  It would be
pretty easy to drill and tap this for a pipe thread sender.  There may be
room to install a second tapped hole for the pressure gauge (0-20 psi?).
Sometime before my next coolant change I will make a plate with one or two
tapped holes.   All electronic gauges would be best, with no worrying about
flexing lines for the pressure gauge.

                                                                  Jay '85
Westy

This communication is for use by the intended recipient and contains
information that may be privileged, confidential or copyrighted under
applicable law.  If you are not the intended recipient, you are hereby
formally notified that any use, copying or distribution of this e-mail,
in whole or in part, is strictly prohibited.  Please notify the sender
by return e-mail and delete this e-mail from your system.  Unless
explicitly and conspicuously designated as "E-Contract Intended",
this e-mail does not constitute a contract offer, a contract amendment,
or an acceptance of a contract offer.  This e-mail does not constitute
a consent to the use of sender's contact information for direct marketing
purposes or for transfers of data to third parties.

 Francais Deutsch Italiano  Espanol  Portuges  Japanese  Chinese  Korean

            http://www.DuPont.com/corp/email_disclaimer.html