I got it resolved. The switch was appearing to go to the ON
positions, but when I disassembled it, it was in fact not reaching
the other position, though it would go to OFF & ON in both position.
I ended up moving the contact a bit higher to reach the second
position and now it works correctly! Thanks everyone for the great
information!!

Timothy

At 2:39 PM -0700 10/29/02, westydriver wrote:
>check that someone didnt jumper the wires on the switch or that they
>didnt run both to the door switch the other after checking bentley
>is that your switch is wired that it has only a single hot wire and
>two grounds. the door switch actually providing a ground path and
>the switch providing a path in the other position. from what you are
>saying i gather that the switches both on settings are working when
>you open a door. from the diagram this would mean someone either
>jumpered the door switch wire behind the light and disconnected the
>other ground wire or there is something strange. because with the
>ground setup almost anything else would cause the light to be on all
>the time.
>jimt

--
Happy motoring!

Timothy in Phoenix,
84 Vanagon "Sparkii"
69 Bus "Buster"