If I needed one, I would check these two sources in the NW US. You didn't
say where you were.

Avverr's, Longview, WA

Campbell-Nelson, used parts dept., Lynwood, WA

See web search, archive search or yellow pages, I don't have the info here
at home.

You might check also with Jerry at NW Connecting Rod in Seattle. Tell him
what you got and he may have what you need in a core or rebuilt head. If
those heads can be rebuilt, he would have the process down. Quality spec
workmanship always from these guys on ANY VW engine, air/water cooled, gas
or diesel. Their Wasserboxer long blocks are just superb. With proper
maintenance these motors will last as long as the originals and longer.

Be aware of the 2 types of head bolts used on these blocks. My Bentley
gives only specs and procedure for the torque to yield 12mm thread triple
hex non-reusable type, but nothing on the 11mm thread 10mm hex. From Jerry,
the spec for the standard 11mm hex bolts is 135/155/165ftpds in stages per
order given, re torque after 1000 miles. If your block takes the 12mm
stretch bolts, they can only be torqued and set once, then followed up
after 1000 miles with another turn, so must be replaced with new per
Bentley procedures given. Most important, because if you use the wrong
procedure for the 11mm bolts you WILL pull the threads right up out of the
block and if you foul up the yield points on the 12mm bolts you WILL leak
and in both cases cattywampus the head.

At 01:58 PM 10/30/2002, you wrote:

>I had two diesel heads checked out and the shop says they both leak. Anyone
>have a good, rebuildable head to sell me?
>
>Ken Hougard