Gary, I am having a rich running condition when the van reaches full warm
(about 10 mins into operation).  I checked the ECU plug pins per the Bentley
and found that between pins 2 and 13 I was getting about 1.5 M ohms of
resistance.  You are supposed to see infinite resistance as one of these
pins is the signal wire to the oxygen sensor and the other is ground and the
two are not supposed to come into contact with each other.  So I figure that
the signal wire to the oxygen sensor is bad.  I ran down to Radio Shack and
bought some of the shielded wire they had ( about $3 for 20ft).  Going to
try to make up a replacement and see if it helps.  Thanks for caring.

Thanks,
Ken Wilford
John 3:16
http://www.vanagain.com
Phone: (856)-327-4936
Fax: (856)-327-2242

-----Original Message-----
From: gary hradek [mailto:hradek@yahoo.com]
Sent: Friday, November 22, 2002 11:18 PM
To: kenwilfy@COMCAST.NET
Subject: o2 sensor wire

Ken,
    I do not unerstand your question?   What is the
nature of your problem?   gary

__________________________________________________
Do you Yahoo!?
Yahoo! Mail Plus   Powerful. Affordable. Sign up now.
http://mailplus.yahoo.com