I just swapped out mine when I changed out my water pump. Even with the pump
out of the way, it took some work to get it out. I ended up using a 24mm
12-point 1/2"-drive standard depth socket and my 1/2" breaker bar to get it
out.

You could also remove the muffler, rear engine hanger and tinwork to get access
to it. If you go this route, replace your motor mounts if they haven't ever
been renewed.

Good luck,

Tim

--- Chris S <mrvolkswagen@HOTMAIL.COM> wrote:
> I shall attempt to replace the oil pressure sender, the one located near the
> lower engine pulley, on an '89 Westy.
>
> Any tricks or pitfalls I should beware?
>
> Thanks!
>
> Chris S.
> www.knology.net/~vw
> http://groups.yahoo.com/group/wolfsburg_campers/
>
>
>
> _________________________________________________________________
> MSN 8 with e-mail virus protection service: 3 months FREE*.
>
http://join.msn.com/?page=features/virus&xAPID=42&PS=47575&PI=7324&DI=7474&SU=
>
http://www.hotmail.msn.com/cgi-bin/getmsg&HL=1216hotmailtaglines_eliminateviruses_3mf

=====
TJ Hannink
Goldibox - 1987 Vanagon Camper, Wolfsburg Edition
Winter Park, Florida
http://home.earthlink.net/~tjhannink/
http://groups.yahoo.com/group/wolfsburg_campers
http://photos.yahoo.com/tjhannink [Vanagon] Album

__________________________________________________
Do you Yahoo!?
New DSL Internet Access from SBC & Yahoo!
http://sbc.yahoo.com