Change the lower o-rings if you can, but I've done the heads twice now and
left the bottoms alone without issue.

----- Original Message -----
From: "Frank Condelli" <RAlanen@AOL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Saturday, December 28, 2002 2:35 AM
Subject: Re: putting 2.1 back together

In a message dated 12/27/2002 5:59:37 PM Eastern Standard Time,
LISTSERV@GERRY.VANAGON.COM writes:

> putting 2.1 back together

       Change the lower o-rings or you'll be taking it apart again.  No
sealant on the o-rings.  Throw the Dirko in the nearest garbage can !  Use
Permatex or Loctite Ultra Copper High Temp Silicon Sealant.  Check the
archives on this and you will see that we have discussed this matter
innumerable times.  Good luck and If I were you I get that motor out of the
van.  You cannot do a proper job with the motor in the van.

Happy Holidays

Frank Condelli
Almonte, Ontario, Canada
<A HREF="http://members.aol.com/BusFusion/bfhome.htm">BusFusion</A> a VW
Camper camping event, Almonte, ON, June 12 ~ 15, 2003
'87 Westy & Lionel Trains
Member: <A HREF="http://www.vanagon.com/">Vanagon List</A>, <A
HREF="http://www.bcn.net/~limbo/">LiMBO</A>, <A
HREF="http://www.westfalia.qc.ca/">IWCCC</A> & Capital City VW Club
Vanagon/Vanagon Westfalia Service in the Ottawa Valley
<A HREF="http://members.aol.com/Fkc43/stebro.htm">STEBRO/Vanagon Stainless
Steel Mufflers</A>
<A HREF="http://members.aol.com/Fkc43/busindex.html">Frank Condelli &
Associates</A> or http://frankcondelli.com