Hi Tom,
Not sure if it's what you seek, but page 19.2 in my manual shows "cooling
fan with pulley" and the bolts bet 15 ft lb/20 nm.  They don't look like
tri-squares, though, more like typical hex bolts, and only three of them.
The allen bolts that hold the water pump pulley to the water pump take the
same torque, and I wonder if they aren't very similar?
tx,
bmc  :)
Ben McCafferty
ben@volkscafe.com

Volks Cafe
1823 Soquel Avenue
Santa Cruz, CA  95062
831-426-1244
http://volkscafe.com

> From: Tom Young <tomyoung1@ATTBI.COM>
> Reply-To: Tom Young <tomyoung1@ATTBI.COM>
> Date: Wed, 5 Feb 2003 13:23:00 -0800
> To: vanagon@GERRY.VANAGON.COM
> Subject: Need a torque value, please
>
> Hi all:
>
> I've separated the large cooling fan from the pulley it's attached to in
> order to clean things up and paint the pulley.  The van is attached to the
> pulley via 4 bolts with "triple-square" heads, similar to CV joint bolts.
>
> Does anybody know the proper assembly torque for these bolts?  I can't seem
> to find it in Bentley.
>
> TIA.
> ---------------------------------------------------------------
> Tom Young                       '81 Vanagon
> Lafayette, CA 94549         '82 Westfalia
> ---------------------------------------------------------------