

| Subject: | Re: Heater fuel pressure question |
| From: | EMZ |
| Date: | Fri, 7 Feb 2003 23:12:45 -0500 |
10 ft is out of the question.... even 6 ft is out of the van. I'll
have to stick to the fuel pump.
Eric 86-VW4x4
vw4x4@fyi.net 86-SS Syncro
Pittsburgh, PA USA 1936-Chrysler
92-Jetta GWC
www.fyi.net/~vw4x4/vw4x4.htm
On Fri, 7 Feb 2003, David Brodbeck wrote:
> On Fri, 7 Feb 2003, Eric Zeno wrote:
>
> > Assuming the fuel has the
> > same weight as water,
>
> Bad assumption. Gasoline = approx. 6 lbs per gallon. Water = approx 8
> lbs. per gallon. (U.S. gallons)
>
> > how high would it have to be?
>
> Reaching back into my fluid power classes...
>
> Pressure (psi) = height (feet) * density (lbs per cubic foot) / 144
>
> Water is 62.4 lbs per cubic foot, so gasoline must be roughly 41.6.
>
> Solving for height...
>
> Pressure * 144 / density = height
>
> So 3 * 144 / 41.6 = 10.4 feet
>
> The bottom of your tank needs to be 10.4 feet above the heater for a
> minimum of 3 psi. The pressure will be a bit higher with a full tank, but
> not much. Anyone want to check my math?
>
> _ _
> __ _ _ _| | | | David M. Brodbeck (N8SRE) Ypsilanti, MI
> / _` | | | | | | +-----------------------------------------------------
> | (_| | |_| | | | @ cyberspace.org
> \__, |\__,_|_|_| "To the optimist, the glass is half full. To the
> |___/ pessimist, the glass is half empty. To the engineer,
> the glass is twice as big as it needs to be."
>Have something to add on this topic today? Revive this thread in the forum »