If you have a black EGR box and a two part cable .............. there is
a little nylon ring on the cable going into the EGR lower side cable
connection. This little ring can slide forward (allowing cable to slip
out) or it could get broken allowing the cable to move in and out of the
receiver. It is a fragile setting to get the cable in the black box and
the cable end through your grease cap with the clip on it.
Hope it is this simple but speedometers fail all of a sudden and a good
spray cleaning with electronics parts cleaner and a few drops of sewing
machine oil might fix the speedometer if that is your problem (don't
touch the speedometer needle, FRAIL is the word for them) leave the dirt
on it.

Stan Wilder

On Tue, 25 Feb 2003 06:14:04 -0800 Tracy Bonin <icculus22420@YAHOO.COM>
writes:
> Good Morning!,
>
> Last night on my way home from school my speedometer started
> freaking out, and not registering the correct speed. I was about
> 15-20 minutes into the trip home, when I looking down and noticed
> the problems. The needle shakes and wobbles like crazy, and it
> doesn't register at the correct speed. For example normally when I'm
> in 4th gear, tach is a the 4 mark, that is 70mph. When that started
> happening though, it was saying I was doing like 55mph, and it was
> wobbling like it was blowing in the wind. Last night at school I had
> taken my wheels, calipers, and rotors off to re-pack my wheel
> bearings, everything went on again just fine. We didn't hit or touch
> anything else, so I didn't think that was the problem. The way it
> wobbles though, it almost seams as if something is loose. Does
> anyone know what is going on here? Is something loose? If so what
> should I tighten?
>
> thanx for the help,
>
> Tracy
>
> 85' GL "Ripple"
>
>

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com