One side came out as 53.8 cc's and 52.4 cc's.
The other side measured at 56.8 cc's and 56.7 cc's.
Tom Young                       '81 Vanagon
----------------- Clip -----------------------
Your measurements are exactly why I measure deck height with the heads on
the engine by crushing a thin brass tube as the piston comes over TDC.
The height below the barrel to the piston isn't relevant if I've got
.028 + clearance.
I've had situations where I swapped around pistons and rods and got near
perfect head to piston clearances.
I used a clear Plexiglass with a hole in it sealed with grease to the
head and I got more accurate results than just open surface. Never done
this to a VW but we used to grind out Fageol / Crosley heads into hemi to
used dome top Pop Meyers pistons and it was critical.
Are you going to try to match them up?

Stan Wilder

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com