Hmm...  I looked that trigger wheel over pretty closely and saw nothing
that looked like it could be separated.  Was I clear that the
distributor design in the Digifant design is quite different than TCI-H?
  Also, the replacement Hall Sender does come with a new trigger and
pin.  Finally, the word I got from Volk's Cafe people is that the pin
comes out.

You've got me curious, though, so I'm going to take a closer look tonight.

Thanks for the suggestion,
-MB

Robert Keezer wrote:
>
> You don't need to remove the pin to remove the Hall sender.
>
> You remove the trigger wheel instead,, carefully(first mark it to
> replace in
> original position), put the dist in a vice, pry carefully with two flat
> blade screwdrivers all the way under the trigger wheel to the shaft, and
> pry
> upwards. Use some penetrating oil if it needs it.
>
>
> Removing the trigger wheel is easy , and it can be done if you are careful
> while  in the engine.
> Make sure you put the trigger whjeel back on in the exact same position it
> was before you removed it.

--
_______________________________________________________________________
Mark Belanger - belanger@fluid.com