Hullo all,
I'm intalling a jumpseat in my westy.  Suprisingly there isn't a step by
step on jumpseat installation in the archives.

It's late night in the garage. I have the battery out (PITA).
I was getting ready to drill the holes for the support bracket that attaches
to the battery casing.  Then I noticed the gas expansion/evaporation tank
that sits under the passenger seat wheel well.  How do you navigate that?
Do you skip the bolt and drill in a self tapping screw?  Any thoughts?
Thanks,
luke

----Original Message Follows----
From: JordanVw@aol.com
To: spons23@HOTMAIL.COM, vanagon@GERRY.VANAGON.COM
Subject: Re: jumpseat cylinder housings
Date: Fri, 7 Mar 2003 23:33:25 EST

In a message dated 3/7/03 7:09:33 PM Eastern Standard Time,
spons23@HOTMAIL.COM writes:

 > I just purchased a jumpseat from the local junk yard that I'm going to
place
 > in my 88 westy.  I pulled all the parts for it except the little cylinder
 > housings that the two front legs secure into.

you dont need these.  you have a westy. it has a plywood (formica or rubber
covered) subfloor. drill corresponding holes in the plywood where the nibs
touch the floor and  spend your time on something else :<)
chris

_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
http://join.msn.com/?page=features/virus