You can start the two bottom studs on the tranny to get alignment.
Did you use a clutch alignment tool on the disk?
Be careful not to let your tranny hang in the disk, it can bend the plate
and you get to do it again.
(it wouldn't turn at all. is this normal?) Got no idea why it wouldn't
turn but you need to address that before you proceed.

Stan Wilder
On Mon, 10 Mar 2003 15:30:42 -0800 Jeffrey Stangeland
<haewolius@YAHOO.COM> writes:
> hey all ---
>
> under my van trying to get the trans back in.... don't seem to want
> to go in...? maybe the splines aren't aligning properly? everything
> was straight and looked good, engine supported with a jack, etc.how
> does this fine tuning get done on the air-cooled vanagon? on my '70
> i could rotate the fan pulley to turn the crankshaft.
>
> another concern i had was when i was removing the flywheel i had to
> lock up the teeth with a screwdriver on thr engine stud to keep it
> from moving, whereas when i reinstalled it it wouldn't turn at all.
> is this normal?i didn't do anything other than install new
> seals....
>
> sure would appreciate some help here.... it's so close...
>
> thanks, jeff
>
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Tax Center - forms, calculators, tips, and more
>
>

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com