Hmmm....

I've replaced the clutch master cylinder a couple of times - though it's
been a while - and I don't remember the bolts holding it in place as going
through the master cylinder chamber.  If they do, I agree, it's a poor
design.  I'd say buy a new master cylinder from one of the online vendors.
Also, if my experience and the experience reported by other list members is
any guide, buy a slave cylinder too as the two cylinders tend to go out
more-or-less at the same time.
---------------------------------------------------------------
Tom Young                       '81 Vanagon
Lafayette, CA 94549         '82 Westfalia
---------------------------------------------------------------
----- Original Message -----
From: "Matt Ratto" <mratto@UCSD.EDU>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, April 02, 2003 4:57 PM
Subject: clutch master weeping

> well, really both of us... but seriously, the clutch master cylinder in my
> 1982 Westy is weeping from one of the mounting bolts that attaches it to
the
> frame (not from the hose going to the slave, but from the bolt directly
> above it.) No other leaks. Does this mean I need a new clutch master, or
can
> I simply replace the rubber o-rings Bentley has listed as being installed
> with those mounting bolts? Does anyone know why these mounting holes would
> go all through to the master cylinder chamber - that's what I really don't
> understand.
>
> thanks,
>
> Matt
> -------------------------------------
> Matt Ratto
> Ph.D. Candidate
> University of California, San Diego
> mratto@ucsd.edu
> http://communication.ucsd.edu/mratto
> --------------------------------------