Larry,

So the spikes are just held in the holes loose? ??  That a great
idea........

Thanks to all the other tips I got from several of you today,, I will hit
Home Depot or Lowes Sat Am for some pressure treated 2X8.  I think I will go
with  9" + 18" + 27 " pcs of wood.. With the bevels that will give me an
aprox.  8x8 contact patch for the tires to sit on ..

Thanks Again ,
Steve D
02 EVC

----- Original Message -----
From: "Larry and Avery Johnson" <larry_avery.johnson@SYMPATICO.CA>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, April 11, 2003 5:19 PM
Subject: Re: I need Help building 3 tier Leveling Blocks/Ramps

Steve D
The foot print of each tire is about 7" x 7" so any of the three sizes would
do. I have this setup myself. I used 2" x 8" and drilled holes through the
set of three so I could insert spikes and hold the three pieces together.
The idea was to be able to use one, two or three boards depending upon the
lift needed. In practice I just drive up the 45� slope on all three boards
until my gauge shows level, apply the brakes and block the wheels.
Remember: sharp side down for the spikes - LOL
Larry

>I need some help on dimensions on the leveling blocks/ramps, I plan to
build
>this weekend..

>I have seen these in the past , so I understand the concept , just not sure
>how long each section needs to be, and do I use 2x6's,  2x8's or 2x10's...

>Any tips would be great, I plan on cutting 45 degree cuts on the leading
>edges to aid in the tires rolling up these ramps..  I also need to keep as
>small as possible to save space..