In a message dated 4/13/03 11:12:31 AM Pacific Daylight Time,
Trvlr2001@AOL.COM writes:

<< After looking intently at the side of my bus,
 (for about 2 hours:)
 I decided to cut the top of it
 at about 3" above the bottom of the window,
 after it straightens out.
 This gives it small welds on a solid surface.
 And more importantly, a small body repair area.
 And I will cut the donor bus about 10"
 (to the inside of the floor)
 So that I will attach it at the bottom of the rocker panel. >>

JohnC,

Be prepared for some painstaking cutting on the donor bus. The reinforcement
runs double under the floor. I cut such a panel for a listee before. It was a
pretty major job. Sadly I did not take any pictures.

BenT