> Hi all,
>      I have been working on putting heads on my 1990
> vanagon. When i first removed the head on the left
> side a cyclinder slipped about 3 to 4 inches out (it
> was stuck to the head). Will this cause a major
> problem if i just slip the cyclinder head back on? I
> have a very tight budget so quick fixes are needed.
>                             Thanks,
>                             Reggie
>                             Wheaton MD

You asked this same question on April 7th.  I sent you a p-mail
explaining that I'd had this same thing happen on 3 different engines
and that after making sure the bottom O-Ring wasn't gouged or broken
(and that the area is clean) that I had just pushed the jug back in
place without problems.

You didn't say ... but did the piston rings come out of the cylinder?
If so, that's a whole different question.

Mike

'84 GL 7 pass
'85 GL Westy