Hey,
I pulled my transmission yesterday due to a slipping clutch. And the clutch
disc was definitely worn out as evidenced by the grooves cut into the
pressure plate by the rivets. No problem there but....................as we
were dropping the tranny away from the engine, attempting to balance it on
the floor jack. I ran off to get a tarp to lay it on, my assistant couldn't
keep the pig balanced on the jack and it dropped maybe 6 inches to the
ground. Again no real problem but I later discovered a large washer that
slips right over the splined shaft coming out the front of the transmission.
Since the throw out bearing wasn't removed yet as I correct in assuming that
it goes there? It would go between the springy forks on the pressure plate
and the throw out bearing. Any input would be greatly
appreciated....................also anything else I should be aware of/do
while I've got it out?
Thanx,

Paul Rogers
85 WWW "el Lobito"
Danville, CA