In a message dated 7/9/03 10:24:51 PM Eastern Daylight Time,
msutts@EARTHLINK.NET writes:

> ,
>     Anyone have some ideas about how to repair the printed circuit behind
> the instrument panel? Mine is completely  chewed up- first the oil pressure
> system went nuts, now the tach doesn't work. Where the circuit meets the
> multi connector is completely chewed up, copper tracks coming off the
> plastic, etc.
>     I can solder well, but am concerned about weakening the plastic further.
> I have the printed circuit from a different model, but it can't be used as a
> whole (tach vs analog clock problem).
>     I'll be in the vicinity of a well stocked radio shack tomorrow......
> TIA
>
>

i have a good '86-'91 printed circuit board ribbon if you need one

chris