Bill if it's like the center window and  I would think so your really
better off with a helper unless your planing on replacing the gasket
when reinstalling. If so just cut the gasket and your done. If you
want to reuse the gasket start from the inside in a corner, place
screwdriver between frame and gasket pry away, then place another one
a few inches away and do the same. After you've got a few drivers
around and all pushed towards the center of the window push the
window out from that corner. This is where you need a helper to make
sure you don;t push to hard and it falls. To me the process is like
removing tire from a bike.

JFF

>OK, folks, I tried the archives and got nothing.  I want to remove the driver
>side rear window to kill some rust there.  How is this best done?  And, can
>it be done by one person?
>
>I swear someone recently posted about how to do this, but I can't find it.
>
>thanks
>
>Bill Marshall
>85 GL Tiico "Pandora's Box"
>Aurora, IL