On 14 Nov 2003 at 14:16, Mike D. wrote:

> (1) The Fuel Injectors all were about 17.5 ohms.  Bentley specifies
> 16-16.4.  Is this a problem?

I can't address the other items, but check the ohm meter reading with just test
lead to test lead.  It will often be about 1 ohm.  Whatever that reading is
should be subtracted from the 17.5, and will likely then be closer to what the
spec calls for.

Also make sure you make good tight contact, and that surfaces are clean when
checking low impedance devices.

tom

------
Tom Ring K0TAR, ex-WA2PHW  EN34hx
85 Westphalia GL Albert
96 Jetta GL The Intimidator
taring@taring.org

"It is better to go into a turn slow, and come out fast, than to go into a turn
fast
and come out dead." Stirling Moss