The right-hand piece can be seen in illustration 38-00 (MG:2, SG:56) as part
071 256 304 B, though a better picture is at 19.2 in the Bentley.  This
bolts to the fan housing in 2 places, one of which is the "front" of the fan
housing, and this latter bolt can be a real PITA to get in.  (Probably why
this hanger frequently gets left out in rebuilds.)  The left-side bracket(s)
can also be seen here as item 11 (071 256 303 B) for Federal or item 12
(Part number unknown) for California.
---------------------------------------------------------------
Tom Young                       '81 Vanagon
Lafayette, CA 94549         '82 Westfalia
---------------------------------------------------------------
----- Original Message -----
From: "Jeff Strickrott" <jstric01@CS.FIU.EDU>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, November 19, 2003 10:41 AM
Subject: Re: 82 Vanagon Heat Exchanger/Exhaust hangers?

> Hi Sean:
>
> The picture would be great as then I know what I will need to fabricate.
The fan shroud has tow holes at the bottom, so it looks like it could
accommodate two such brackets. I assume that the go between the fan shroud
and the where the crossover pipe mounts to the heat
> exchangers?
>
> Regards,
> --Jeff Strickrott
> 82 Westy, South Florida
>
>
>
> Sean Garrett wrote:
>
> > There is a bracket on the passenger side of the engine towards the rear.
It hangs off of the fan shroud. My shop forgot to attach at this point and I
have been running now for about 2 yrs like that. However if you like tonight
I'll try to remember to snap a pic for.
> >
> > Sean Garrett
> > 81 Westy (his)
> > 95 EVC (hers)
> > 87 Syncro (Subie project)
> > 82 Parts Vanagon (need a part ?)
> > Central Arizona
> >
> > > -----Original Message-----
> > > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf
> > > Of Jeff Strickrott
> > > Sent: Wednesday, November 19, 2003 11:13 AM
> > > To: vanagon@GERRY.VANAGON.COM
> > > Subject: 82 Vanagon Heat Exchanger/Exhaust hangers?
> > >
> > >
> > > Hi All:
> > >
> > > I am getting ready to mount the heat exchangers and exhaust to my new
> > > engine for my 82 Vanagon. I am sure that there must be something else
> > > that holds up the rear portion or the heat exchangers and
> > > supports some
> > > of the weight of the exhaust. I have looked at the parts disassembly
> > > diagrams on my ETKA, Bentley's and Haynes, but do not see
> > > anything like
> > > this. I know that the older buses had something, any idea what the
> > > Vanagons used?
> > >
> > > Regards,
> > > --Jeff Strickrott
> > > 82 Westy, South Florida
> > >