I don't have much experience on the bench installing pins I use a stand and
I can spin the block so the rod stands straight up.  I would think you could
bend a coat hanger to support the rod so the pin could be installed
Bob
----- Original Message -----
From: "Jeff Engel" <rambler64@SHAW.CA>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, January 25, 2004 11:13 PM
Subject: engine assembly

Hello
I am in the process of assembling a 2.1 out of a 1990 westy.Was wondering if
anyone out there has had experience with cylinder and piston install  with
the engine removedand on a workbench? Read bently and they talk about a
special tool install the small clips for the wristpins. Can a person use any
type of homemade tool or do I have to hunt down a special VW tool for this ?
I have been getting excellent tech support from Bob Donald so far. Also are
there any other things to be careful of when doing this job?
Thanks Jeff 1990 Westy