Its a reuseable glide slide type tooling to drill new hole for the spring lock on the shift lever.

Joe

-----Original Message-----
From: Tom Miller <tmiller@VCMAILS.COM>
Sent: Mar 12, 2004 1:29 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Berg Shifter TOP

The sleeve has a pilot hole in the side of it where you run a drill bit to
dimple the shift lever for the new set screw location which is also moved up
3/4" by the spacer.  The spring retainer is reused and the set screw tht
holds it in place drives home on the new dimple you just drilled.
Tom Miller
----- Original Message -----
From: "James V" <tornadored@EARTHLINK.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, March 12, 2004 4:19 AM
Subject: Re: Berg Shifter TOP

> On 3/11/04 9:23, "Al Knoll" <al_knoll@PACBELL.NET> wrote:
>
> > position.  Berg has a set screw retained ring on the shaft to position
the
> > spring.  This design could be improved upon as the retainer needs only
hold
> > the spring in place.
>
> Doesn't the Berg use the existing spring retainer?  Can't this be reused
> similarly - slid up 3/4"?
>
> From what I understand from reading the Berg instructions that were
posted,
> the kit includes a round sleeve that slides over the shifter shaft (below
> the pivot).  What is its purpose?
>
> Thanks,
>
> James V
> 90 Carat
>