You guys are just going to mess around and do a half assed job on these
heads.
Just get some rebuilt heads and move on.

Stan Wilder

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf
Of Ben huot
Sent: Tuesday, March 30, 2004 8:22 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Valve guide removal / replacement

Hey Fitchen, Are the guide tight or loose, why do you want to remove them?
Valve come out from the seat / piston side(inside engine). Sometime, a
combination of Heat, drill and presses is needed, this is a delicate job and
not a do it yourself job unless your well equiped, when they are dificult to
remove, the head is sometime damage where the guide goes, so that is why
they sell oversise OD guides.

Look at page 15.5 AC Head, you will have a better understanding of the
procedure. I never change guide in a wasser but i imagine that it is the
same prosedure.

Regards, Ben
http://www.benplace.com/