I noticed that my VC is going bad (acts like a brake in not so tight parking
lot turns) so I want to pull my drive shaft until I can get a replacement.  I
know that I should mark the driveshaft to make sure I put it back in the proper
alignment, but I wonder if anyone has a good method for doing that.  I was
about to grab a dremel tool and score a mark on all four flanges but then I
started thinking that the reason the shaft has to be aligned is for balance.
Would such a mark have a significant effect on the balance?  Any other ideas?
Thanks

Jeff
86 Syncro

__________________________________
Do you Yahoo!?
Win a $20,000 Career Makeover at Yahoo! HotJobs
http://hotjobs.sweepstakes.yahoo.com/careermakeover