

| Subject: | Re: How to disable oil warning buzzer? |
| From: | Chris DeLong |
| Date: | Thu, 13 May 2004 20:00:15 +0000 |
Good point. That would probably work as well. Jsut make sure that hwen you leave the flexible printed circuit disconnected that it doesnt end up in a manner that can chafe or otherwise damage the flexible circuit. Chris DeLong Fine Tuning 206.427.4777 www.finetuningperformance.com Seattle, WA USA >From: mark drillock <drillock@EARTHLINK.NET> >Reply-To: mark drillock <drillock@EARTHLINK.NET> >To: vanagon@GERRY.VANAGON.COM >Subject: Re: How to disable oil warning buzzer? >Date: Thu, 13 May 2004 12:46:04 -0700 > >That would work but it would be much easier for him to just unplug the >ribbon cable from that board. Remove the cluster top cover to get to the >back of the speedo housing and gently pull that plug out of the speedo >case. Just leave everything else together so when he gets around to >fixing it he won't have to take it all apart again. > >The whole concept is faulty as the oil warning system is important and >should be fixed or at least made to always use the low rpm switch only. >He does not understand how the system works or he would know that VW >designed it so that leaving the 2 pin connector near the motor undone >FORCES the high rpm oil switch to trigger the low oil pressure alarm. >This was a smart design but confusing to some. > >Mark > >Chris DeLong wrote: > > > > REmove the instrument cluster. Remove the speedometer. Remove the back >of > > the speedometer. Remove the little printed circuit board. Be careful >when > > remove the blue plastic flexible printed circuit. Reinstall everything. > > > > Chris DeLong > > Fine Tuning > > 206.427.4777 > > www.finetuningperformance.com > > Seattle, WA USA > > > > >From: Vanagon Man <vgonman@MSN.COM> > > >Reply-To: Vanagon Man <vgonman@MSN.COM> > > >To: vanagon@GERRY.VANAGON.COM > > >Subject: How to disable oil warning buzzer? > > >Date: Thu, 13 May 2004 14:15:34 -0400 > > > > > >Their is a short in the system...I tested with a pressure gauge on the > > >motor > > >and all is well............i tried to unplug it at the motor and the >light > > >STILL flashes and the buzzer goes off..............I want to disable it >for > > >now until i have the time to trace those 2 long wires or run > > >new................... > > > > > >Adam P > > >Charleston,SC Coburn, WV > > _________________________________________________________________ MSN Toolbar provides one-click access to Hotmail from any Web page � FREE download! http://toolbar.msn.com/go/onm00200413ave/direct/01/
Have something to add on this topic today? Revive this thread in the forum »