That may be taken as a joke, but there's a good probability he's right. Also
make sure that you have the right end of the bit inside the drill.

Jason

----- Original Message -----
From: "George Goff" <THX0001@AOL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, May 14, 2004 1:20 PM
Subject: Re: drilling through sheet metal?

> In a message dated 5/14/04 3:53:53 PM, craigoda@GMAIL.COM writes:
>
> << I've also tried to drill a hole into the pillar where the fire
> extinguisher is attached to.  I haven't had any luck here either.
>
> Are there any special techniques? >>
>
> Stop running it in reverse.
>
> George
>