

| Subject: | Re: Alignment Question |
| From: | tmiller |
| Date: | Thu, 10 Jun 2004 20:00:08 -0400 |
I would just remove the cover on the steering wheel and remove the nut holding the wheel and recenter the thing and put it back together. Jim Henry wrote: >Ryan, >Your alignment guy probably forgot to (or neglected to, because it is pain) >adjust the tie rod lengths so that the steering wheel was centered as well >as the wheels aligned. Your alignment is probably ok, but the off center >steering wheel will drive you crazy (maybe not). Call your guy and tell him >the problem, he should probably say, "bring it back in and he will fix it" >Make sure he checks the alignment after he fixes it. Take it back after your >trip. > >Good luck, have fun on you trip. > >Jim > >Jim Henry >Durham, NC >85 RX7 GSL-SE >84 RX7 GSL-SE >85 RX& GSL-SE parts car >85 VW Westy Camper >95 Aurora (what a pig) >96 Olds 88 LS (I drive a lot of miles) >97 GEO lsi (wife's car) >86 RX7 (son's car) >Are there any others back there under the trees? > > > > > > >>-----Original Message----- >>From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] >>On Behalf Of Ryan Dawson >>Sent: Thursday, June 10, 2004 2:35 PM >>To: vanagon@GERRY.VANAGON.COM >>Subject: Alignment Question >> >>Hi Everyone, >> >>I recently replaced the tie rods on my 1984 Vanagon Westfalia >>and took it in for an alignment. When I checked the >>alignment before taking it in, I figured there was a 3/8" >>difference between the front and rear of the wheel measured >>from centre. The gentleman and the shop said it was about a >>1/2", not a big issue. The question that I have is now that >>I have picked up the van, when drive in a straight line, I >>have the wheel slightly cocked to the left. Since I just had >>the alignment done, would this be an issue with the steering >>rack, or just the steering wheel, or something else? Any >>thoughts are appreciated. >>I'm on my way for my camping trip in about a 1/2 hour and >>want to make sure that this isn't going to be a problem. >> >>Thanks, >>Ryan >> >> >> > > > >
Have something to add on this topic today? Revive this thread in the forum »