Hey Everyone,

I replaced the o-ring on my rear heater yesterday - and I am wondering about
bleeding the heater when I start the van up again.  Is this necessary or
will it "water-hammer" if I don't?  I blocked off the inlet and outlet
lines, so I only lost the coolant that was in the heater core.

Also the little white plastic bleeder screw broke in half when I tried to
unscrew it yesterday.  I left the part that broke off where is was and
screwed the top half back in tightly.  Can this part be purchased relatively
cheaply from the dealer?  Does anyone know the part number?

Thanks for all the help!

Andrew

*******************************************************************
CONFIDENTIAL - This e-mail transmission and any documents attached to it may
contain information that is confidential or legally privileged. If you are
not the intended recipient, or a person responsible for delivering this
transmission to the intended recipient, you are hereby notified that any
disclosure, copying, distribution, or use of this transmission is strictly
prohibited.  If you have received this transmission in error, please
immediately notify the sender and destroy the original transmission,
attachments, and destroy any hard copies.