Hello All:

I purchased an Ignition Switch for my 2.1 Carat...my
mechanic said I could check it by dropping the plastic
panel below the steering, pulling the wire connector
plug off the old switch, attaching it to the new
switch and turning it with a screwdriver.

I did this...at the first position the power is on
(fuel pump runs, oil light blinks, etc) but when I
turn the screwdriver a little further to engage the
starter all is hear is a clicking sound from somewhere
under the dash...the engine doesn't begin to turn
over.

Some history...last week my Low Beams went out while
driving. I could turn on the High Beams...but had to
hold the lever in as it wouldn't stay in the High
position.   I got home by holding in the High Beams.
Next day the lights worked fine (low and high)...but
one of the H3 bulbs was out...so I replaced it.

All was well until the next morning when I went to
start the Van and there was no response upon turning
the key.

Any suggestions???

Thanks!
Kevin

__________________________________
Do you Yahoo!?
Yahoo! Mail Address AutoComplete - You start. We finish.
http://promotions.yahoo.com/new_mail