On Wed, 12 May 2004 22:14:46 -0300, Giasson, Pascal (DNR/MRN)
<Pascal.Giasson@GNB.CA> wrote:

>Does anyone have any idea how to replace the rubber grommet that seals the
>fuel injector electrical terminal?  I looked in my Bentley and Haynes with
>no luck.  Bus Depot sells them (part no. 810 972 525) so I figure there
must
>be a way to replace them.  Mine are missing or cracked.  I thought of
>wrapping the terminal with an electrical tape to keep water/dust out of the
>connection but would rather put on the grommets.
>
>Thanks
>
>Pascal
>1984 Westfalia

I ended up bying the special tool to release the wires from the connector
blocks (from Bus Boys), I have used little screw drivers in the past but
that little tool works a whole lot better, and worth $3 in saved
frustration and possible damage to conectors.  I then greased the tiny
holes in the new rubber gromet/dust caps (from Bus Depot) with dielectric
grease and gently pushed the the wire with the female connector still
attached through the holes, worked alot better than I thought it would
given the small size of the hole.  Very inexpensive project but help keep
those electical conections protected from the elements.

Pascal
'84 Westy